Recent content by Geekie1

1984 V20 Cuddy For Sale Best Offer 1984 V20 Cuddy - 1985 Yamaha 150 - Best Offer My boat is basically a fresh water boat. The first 3/4 of its life was spent on the Delaware River near Bristol PA. (tidal but fresh water) When you inspect it you will notice that it has never had anti-fouling...

This is my V20 about a week ago at Sea Isle City NJ after fishing. Caught alot of short flounder. I managed to get flounder slime on some of the teak below. This is the result of the repair and refinishing of the rod boxes. Both the port and starboard rod boxes were cracked and broken so...

I had a slight accident and bent the stainless steel frame on my 84 V20 cuddy swim platform. I am not sure it can be straitened. Anyone out there have one they want to get rid of? Geek

I am into re-doing all of the teak on my 84 V20 cuddy. I am looking for the on-deck teak rails on the port & starboard side of the sliding cuddy hatch. Does anyone have restorable teak rails? The current rails on my V20 are not in the best of shape with some splits and dents and will require...

Hi gang, I am going to replace my helm dashboard with black Starboard. Also on the port side, I want to cover the current black vinyl surface with black Starboard. What thickness Starboard should I use for the dash and can I get away with 1/4" starboard to overlay the port side vinyl? Would...

Hi All, I have a small problem and I am going to ask for your help. My V is currently in Cape May County NJ and I am in Doylestown PA, about 110 miles apart. My V has two small bow cleats that I use for docking lines. I have a 10" cleat that I want to install between the sliding hatch and the...

I re-finished some of the teak on my V. I cleaned the teak with 25% Clorox, 75% H2O, used teak brightener next, sanded with my ROS, and finished with Sikkens Cetol Natural Teak (satin finish). 3 coats of Cetol with 00 steel wool between each coat. I have used Cetol before, and if done properly...

My 84 V20 has a Todd pivioting pedestal helmseat. I also have a split (front and back facing) seat on the port side. I would like to get rid of the split seat and replace it with another Todd helmseat. Anyone have a used one available for sale and how much $??!

I need an aluminum bracket to mount a used VHF radio I just bought. The mount I need has 7" to 7-3/4" between the yolk ears and needs to be at least about 3-1/2" high to the mount knob screws. My boat is used in saltwater so steel won't do.

I can't have my bimini top up at the same time I have the outriggers up. The bimini gets in the way with the outriggers vertical. I need to move my outrigger gunnel mounts rearward so that I can use both at the same time. When I move the outriggers, I will need to fiberglass the hole. I also...

I didn't want to highjack the "Auxilliary Motor" thread so I started this new one. I have a V20 cuddy with a 150 Yamaha and with gas prices as they are and how prices may get I am seriously considering installing a kicker. I go offshore alot and do some trolling from time to time depending on...

Hi all, I was down in Fortesque NJ (Weakfish Capitol) a few weeks ago just cruisin through. South on the road that runs along the Delaware Bay front there was a V20 that looked like it had been there for some time. I only checked it out briefly and it looked pretty sad. I don't remember the...