Recent content by Hammerhead

  1. Hammerhead

    New boat ramp issue

    We hava new ramp in town. It looks nice,..all fancy BUT, the ramp itself is on such a slight pitch not just me but, everyone has to dunk the rear wheels of their tow trucks/cars under water to deploy boats. This includes both the big 24's and lil 16's. Before I start a making calls and becoming...
  2. Hammerhead

    Impeller woes.

    The other day, I wanted to but.,couldn't go out on the water. I figured I'd burn the gas at least out of the carb while it sat on the trailer. I hooked up the ears,..started the boat. It ran at idle fine. Then I noticed a whirling noise. Then smelled,..Rubber??? Looked over the aft..Holy...
  3. Hammerhead

    Back in...

    tho' under a new name. I'm actually "Hammerhead",..Dunno what happened but, I haven't been able to log in so I reupped under "Wavesailor". I'll try and straighten it out later. Right now it's jus nice to be back. I hope all is well with everyone. I've been stuck up in the Asheville area for...
  4. Hammerhead

    Trailer brakes PIA

    Been so busy I haven't had the boat out for awhile so, I hooked it up and.....aaacckkk!!! The trailer would'nt move. the front wheels were locked. I jacked it up, removed the two front wheels leaving the hubs alone,..( after beating on'm with a hammer ) and dragged the boat to the street. Then...
  5. Hammerhead

    One for the nailbangers....

    ...All hail..... This guy is my new hero. Notice...NO hard hat either. http://www.break.com/index/skills-with-a-hammer.html
  6. Hammerhead

    Lightning protection

    What's anyone here do about lighting protection...aside from the obvious...get outta dodge. Here in Florida it's kinda a cat and mouse game tryin' to skirt around storms. can't always get away. What's the best...if any protection? A sailboat I crewed on had the masts grounded to the keel. We...
  7. Hammerhead

    Yo MJ

    A kid hit my drivers side windshield today with a golf ball and busted it to bits. Any chance you still hava replacement? Congrats on the motor.
  8. Hammerhead

    Need windshield part

    The piece of glass on the helm side. Kinda angled. '77..Cuddy. TIA
  9. Hammerhead

    Boater issue with Court ruling

    Not sure if this has been posted yet or if it's something that'll take care of itself. Couldn't hurt to call our reps tho'. http://www.tcpalm.com/news/2007/aug/08/us-district-court-ruling-threatens-recreational-bo/
  10. Hammerhead

    B.O.L.O.

    Approach with extreme caution. Has been know to bite of more than she/he...(we're really not sure)... than "it" can chew. Last seen on the View spewing anti-American rhetoric.
  11. Hammerhead

    Cuddy cabin doors

    Neighbors cat kept gettin' in the cabin while it was parked in my yard. I tossed together these doors. The top on folds back and then they both open to the pass seat. Dunno what OEM but this works. Yep...that's the "bucket" no boat can doo without.
  12. Hammerhead

    Swordfish in Bay

    Read a story of these things getting caught in Bisycane Bay. ( Miami )
  13. Hammerhead

    New motor

    The 165 inline 6. Took it out for an extended break-in ride. Started right up. I took it easy and varied the rpms for about an hour then, headed out to sea. Rode around for awhile and trolled back in. It runs alot smoother and is already faster w/o going to WOT.
  14. Hammerhead

    Repower I/O Qs.

    My 165 inline 6 finally croaked. I dunno if it's just a head gasket or worse but since it's over 30 years old I figure it's time to repower. Question is..just replace the 6..go with a V-8 ??? or is there a inline 4 available? Any tho'ts? Power wise the setup now is OK...I'd like better...
  15. Hammerhead

    Tilt problem.

    Outdrive won't trim up. The down button works fine. Up does nothing. No click, buzz or anything. I removed the switch and cleaned'm, ( all three ). checked the fluid. Seems if the trim motor was shot it wouldn't work at all. It's a '77 V-20 165MC I/O. TIA for any info.
Back
Top