Recent content by pancake

i decided to start a new thread since most of the fuel tank replacements that i have seen are for the cuddy or some other version of wellcraft. mine is a 1984 20' Fisherman Center Console that needs to have the fuel tank replaced. I have pulled the fuel tank and measured the tank. The 1st...

the green wire that is on the fuel tank near the fuel gauge sending unit is connected to where on the other end? thanks its a 1984 center console fisherman.

trying to pull a 150 HP outboard from the transom but it seems stuck with what looks like 3M 5200. will it be necessary to pull the 4 bolts as well to remove the outboard? any tips?

Ok i have a 1984 20 Fisherman with a 2001 150 hpdi yamaha currently installed on a 20" notched transom . I wanted to raise the motor with a manual CMC jackplate but it looks like i may have steering cable issues, so is the best way to get the 5 " increase i need to get the motor out of the salt...

interested in raising my Yamaha 150 2 stroke outdrive on a jackplate so that my motor ,trim pump etc. is completely out if the salt water when its sitting at the dock. the boat is a 1984 20' wellcraft fisherman center console. i've read the posts available and will do it over the winter. Does...

i'm considering relocating my single 12 volt battery fromm the rear bilge area to the someplace in the center console area on my 1984 fisherman. i would like to reduce the weight in the stern. Has anyone done this? thx

what are you folks using to glue wood to wood? the epoxy i used did not hold up well when exposed to rain /sun? thanks

Has anyone tried to keep water from draining off the deck and going into the fishbox behind the seats, it then drains into the bilge along with dirt/debris ( or the one up front ,at least that drains overboard). Can you seal the hatch so water won't seep in?