Search results

Near done

Built some plywood cabinets. Planned to paint but they looked too nice. I love wood…

Added hardwood plywood and then textured it.

Started putting back in October

Removed interior walls as they are layed on top of floor. Took paneling off walls and removed all insulation. The original floor was 1 1/4” wafer board tongue & groove. A precursor to OSB.

Took it down to floor joists

Spent the past two years putting the river house back from Idalia and Helene. Gulf coast, Suwannee, Fl. I was doing weekends on the project until about this time last year when I decided to go after it full time. It’s just a trailer 2/2 about 4’ off the ground. But, it’s waterfront property...

Scook, being anti Trump doesn’t make me anti-American. Truth matters to me. How can you believe anything he says? Better question, how do you look up to a man with so little character as to propagate a lie for his own self interest?

Master negotiator, president trump aint. He’s having to back off tariffs as the inflationary impact is more than MAGA can bear. Never mind the entire premise of making a trade imbalance an “Emergency” that would give him the authority. The courts will likely take away that authority. What...

10-4. I had a death grip on the drill and side handle as it was a rod holder, needed the angle, so I was working off the pilot bit, expecting it. It didn’t matter…

I agree, but there is a time and place. Your kinda making my point

Interestingly, income tax never stopped being deducted from my Pay. I feel the IRS should cease to function first…. In any shutdown.😳

I got a nice boo boo on my topside from hole saw grabbing, 1/2inch drill almost broke my wrist

Seal the core if it has one would be my only other recommendation. That Scook just handed out some golden tips to help anybody looking to make a hole

Plus materials and beer😁

Well the going rate is a nickel an hour

Wow, thanks for the compliments. Made my day for sure

On taking it apart, I had equipment to make it easier. Wellcraft used vinylester putty on top of stringers to bond cap to hull. Craploads of ss screws under that rub rail and silicone there as well. Using steady upward pressure on cap with forklifts (hull literally hovering off two ropes...

Big project. I had my cap off. I feel the only issue you might have is the bulkheads. Center console has the raised deck so the foreword most bulkhead is really tall so that it supports the casting deck. Using the same year hull almost assures you the stringer height is the same.

Besides there is contingency money for snap. The ones which hold the cards are just trying to inflict as much pain as possible on the poor. Can we agree that whomever is in charge should not wait until the last minute to fund the govt. no more golf or vacations until they figure this out.