Search results

Is seafoam a good option to keep the carbs clean from season to season on a 1992 200hp merc?

Added to my album with new boat pictures of my finished for now Sport 20 1989 Wellcraft. I guess when I get over 100 post I can do a gallery with all my rebuild pictures. http://www.wellcraftv20.com/community/album.php?albumid=100

1992 200hp black max. Just got it in the water today first time this year. Mods I did this winter. Added 2nd fule tank, but have not used it. changed stator and voltage regs, they didn't go out on me but the few windings were loose so I replaced it before it fales me. Did power packs last...

prop nut torque and procedure? I have a 1992 merc 200hp black max and putting the prop back on want wanted to know the proper procedure Almost ready to hit the water :):sun:

I am replacing the stator and voltage regulators. and if there is anything to look out for.

The plot thickens, planed to just do some patch work but as I dug into it the whole thing was wet so I decided to rip it all out from the inside. looking as I pulled it out looks like wellcraft made the transom out of 1.5'' thick plywood and put 2 relief cuts to let it curve a bit. so I was...

check it out. http://cgi.ebay.com/ebaymotors/1989-WELLCRAFT-20-FT-SPORTFISH-DUEL-CONSOLE-_W0QQcmdZViewItemQQhashZitem19c3d195c6QQitemZ110659474886QQptZFishingQ5fBoats

My 89 sport 20 has a 94 200hp black max offshore Merc, everthing I have found said I need a sending unit. can't seem to locate one online, but ebay has OMC sending unit which I thought I could just mount it to the motor bracket as long as the lever moves with the bracket that tilts the motor...

I have a 14.25x19 SS now and it takes off quick and tops out at 43mph on GPS at 59K rpm. Think of a 14.25x21 to give me a better gas mileage and more top speed to get me to my fishing holes faster.

When do you think you should paint the gel coat a V20 vs. buffing it?

Wondering if anyone knows where to get the plastic strip that goes under the rope that goes in the rub rail? It is a plastic strip that keeps the screws from going through the rubber rub rail part, I think.

I have a 1989 v20 center console I have had it for several years and the floor is getting softer so I am going to take the top cap off and refiberglass some new wood in the floor, and check transom and stringers. Not quite sure if the top comes of as easy as just taking the screws out of top...

This next fall I want to pull the lid off of my center console, the floor is soft on the stern side of the boat. so I want to fix it from underneath, and also I know I have a bad spot in the stringer in the front so, I would like to see the rest. Would it be better to just cut the floor out vs...