Ok Fix it time!!
- Thread starter macojoe
- Start date
Mac_Attack
God
You do good work! Bill Mc ;D
chumbucket
God
Show them all the work I did........................... :
macojoe
Administrator
Ha Ha Ha 
What work!! You to busy for you friends now!!
I had to do all by my self!!!!!!! Even my kids were not around!! Except my daughter the first day to help sand the deck!!
But if you hurry you can get in on the paint!! I am all done with the fixing!! and the floor is all filled and sanded.
I have to ru to the hardware store right now to get a brush for the edges. Then I will clean with Xcline and I will be painting in a hour!~! You have just anough time to get here ;D
I will have more pic later today!! I am off to the store! :-*
What work!! You to busy for you friends now!! I had to do all by my self!!!!!!! Even my kids were not around!! Except my daughter the first day to help sand the deck!!
But if you hurry you can get in on the paint!! I am all done with the fixing!! and the floor is all filled and sanded.
I have to ru to the hardware store right now to get a brush for the edges. Then I will clean with Xcline and I will be painting in a hour!~! You have just anough time to get here ;D
I will have more pic later today!! I am off to the store! :-*
chesapeake724
Junior Member
Very nice. It looks waaayyyy better than what you had. Nice job.
macojoe
Administrator
Ok here is the almost finished deal!!
All thats left is to tune the doors on the rear. I put the hinges a bit tight toghter and they are binding. Easy Fix
I have to make the anchor Pilpit maybe CB will make here this time???
But the paint is done, starboard is done, floor patches all done.
reinstall the engin cover ready to fish!!
All thats left is to tune the doors on the rear. I put the hinges a bit tight toghter and they are binding. Easy Fix
I have to make the anchor Pilpit maybe CB will make here this time???
But the paint is done, starboard is done, floor patches all done.
reinstall the engin cover ready to fish!!
macojoe
Administrator
Ok here is the engin cover.
Note I made a new set of rod holders!! I replaced the teak pieces on the back with 3/4 starboard, I bought all new holders $2 each Walfart, and a donated knife holder from CB in the middle!!
Also I added a full cutting board on the top, made of 3/8 starboard.
And I was to cheap to buy a new handle so I made one out of 3/4 starboard. don't look so good but it works!!
Note I made a new set of rod holders!! I replaced the teak pieces on the back with 3/4 starboard, I bought all new holders $2 each Walfart, and a donated knife holder from CB in the middle!!
Also I added a full cutting board on the top, made of 3/8 starboard.
And I was to cheap to buy a new handle so I made one out of 3/4 starboard. don't look so good but it works!!
reelapeelin
God
That's a LOT of work, MJ...good stuff...engine cover handle looks good and rod-holders w/the cuttin' board...looks like you're bout ready to go!...
;D
;D