Prop needed for original Chrysler 135 OB (1976)

S

Silvermax

New member
Engine was used in fresh water and compression was like new. Had repaired and runs great, but needs a prop, and If anyone may have the right one or point me to that, I appreciate. I also do not have a trim control except for the old method of pulling up on the cowling and resetting the pin/bolt in a different hole, so I ask is there a better way to raise the engine from inside the boat
(an add on leverage bar/handle or something) ? I am 68 and it is heavy for me.

Thanks
 
They have handles at all the boating supply places like West Marine Exedra set foot on the motor to give you leverage for this for that exact purpose
 
I have a handle for my old 115hp Merc tower of power inline 6 engine. Makes lifting it much easier. So yes, they are made.
 
You must log in or register to reply here.
Back
Top