FIRED HER UP TODAY MOTOR NG

captbent

captbent

Junior Member
:'( FIRED HER UP TODAY MOTOR RUNS WATER PUMPS GOOD BUT I KNOW THE 470 MOTOR IS BAD #4 CLY DEAD NEW PLUGS , BLOW BY SMOKE AND KNOCK NO LEAKS AT ALL ,OUTSIDE OF MOTOR VERY CLEAN INSIDE OF V COVER VERY CLEAN AND NO WATER IN OIL CLEAN TOO, BOAT WAS FREE SO I MIGHT PULL MOTOR AND REBUILD IT, HOW HARD TO PULL MOTOR I SEE FRONT MOTOR MT NOW IN THE BACK WHAT IS IT LIKE A BELL HOUSING ON A CAR, I HAVE REPLACED AND REBUILT MANY A MOTOR IN CARS AND TRUCKS AND A FEW INBOARDS BUT NEVER A I/O LIKE I SAID BEFORE I/Os ARE NEW TO ME , ITS THE ASS END THAT IS NEW TO ME,TELL ME WHAT YOU THINK IM NOT INTO HER FOR MUCH JUST THE TRAILER NOT TO LUCKY NOW TAKE A LOOK AT MY PICKS [THANKS ALL]
 
O AND THE OUTDRIVE DOES NOT GO DOWN MOTOR RUNS STRONG WITH THE UP BUTTON, AND NOT WITH THE DOWN I JUMP OUT THE DOWN SEL AND MOTOR SOUNDS WEAK AND DRIVE DONT MOVE
 
look and feel around the rear of the motor. There are 2 bolts holding it to the bell housing which is mounted to he transom.
You need to pull the outdrive to get the motor out. The out drive shaft goes into the bell housing and then into the engin coupler. The engin coupler is a big rubber thing with a metal sleve inside to take the shaft. It is bolted on were the fly wheel would be in a car.

If you take your time and find all the things that have to come apart first, then it will be easy.

I put a engin lift right in my boat on plywood. lifted motor and pulled out. after I tok the engi lift and put on ground and lifted motor out to the ground.

Ck the engin coupler out good!! I put my motor back in and 2 weeks later i guess it could not handle the new torqe and broke!! Had to pull the motor again to replace it!!
This is a good time to check all!! as there are things you can't get to when the motor is in the boat.

As for the power tilt, the motor goes up but not down. There is a selanoid in there that tells it were to go, it may be bad or you have a wire rotted off it?? But the motor and pump sound good, or you may have a bad switch??

Another idea is to take it out, fiberglass the hole add a braket and have a full transom outboard!!  ;D

good luck let us know how you are making out!!
 
i was thinking of buying a rebuilt longblock about $2000 they say its a 200 hp motor. will the stock 170 hp outdrive be ok,
 
you will have to ck with mechanic?? When i had the 165hp i got a 200hp I had to have the gears changed??
 
You must log in or register to reply here.
Back
Top