Prop swich help

T

Tommydoe

Member
Has anybody installed a anti theft lock on prop ? I switched to a stainless after maiden voyage and the aluminum aluminum one had a washer to stop nut from nackn off . The lock doesn't have i ran sunday didn't loose it but was nervous.
 

Attachments

  • 20170625_132632.jpg
    20170625_132632.jpg
    37.3 KB · Views: 19
  • 20170625_132702.jpg
    20170625_132702.jpg
    46.3 KB · Views: 17
Not sure how those prop locks work. But I can see you have a Mercury engine and the lock nut and the bendable tab washer work on the stainless just as well as the aluminum props. Is there room on the threads to have the regular nut and washer first, and then the lock over it to prevent access to the nut? For that matter why not just take the prop off when the boats not in use? Can't steal what's not there. :head:
 
Not worried about theft i just pulled it off the spare outdrive & i put back the same way . I don't think that there is enough room for both but i guess i can just put the other nut back on & leave lock off & yes sir it is mercusier. I have 2 spares i got when i bought the motor .
 
I bought a Mercury that had one of those mcgard prop locks, and it didn't use the locking washer either. The guy I bought it from said it had been on there for awhile and no issues. I took it off and went back to a regular prop nut and lock tab washer since I wasn't worried about it walking off on a trailer in my yard.
 
Didn't back off i took my factory aluminum one off due to being excited & going out at low tide & getting out of channel , i had 2 spare props both ss .they had locks on them so i put on my set up same as that .i have heard bad stories about props coming off at ramp. I ve been out 5 times no issues still nervous
 
You must log in or register to reply here.
Back
Top